Shed started at last...
The shed is finally being erected. At least the frame went up over the last two days, but work has now halted. They cannot get their scissor lift into the section behind the shed in order to put up the rear wall sheeting, without running over the water mains pipe. So I am not sure how it will be resolved at this stage.
Apparently they were going start putting up the steel for the house proper today, but - would you believe - they could not bolt the apex rafters together! There is not enough room inside the apex for a long enough bolt to be thread through. Hard to explain, but the designers overlooked this critical small detail. The fabricator has had to take the offending sections back to the workshop and weld the rafters together at the apex. The plus side is that the building will be even stronger.
I went to the solar guy's workshop, and my off-grid system has been tested and ready to go! I just need a shed to put the solar panels on, and the system and batteries inside.
Comments
Post a Comment